|
Sometimes your amp will have a diagram for bridging. As mentioned below, if your amp does not claim to be able to bridge please don't do it. ... Speaker Positive to Channel 1 Positive, Speaker 1 Negative to Channel 2 Negative and same again for Channels 3 and 4 + Speaker 2. It's the same for all bridgeable amps. Don't use...
|
www.wikihow.com/Bridge-an-Amplifier
www.wikihow.com/Bridge-an-Amplifier
|
|
|
|
Most car amps can handle a 2 ohm load, while some can go as low as 1/2 ohms. How do you bridge an amp?; First, make sure that the amplifier you have is bridgable. If you try to bridge an amp that is not designed to be bridged, you can damage the amp. ... Bridging an amp...
|
www.diyaudioandvideo.com/FAQ/Wiring/
|
|
|
Increasing the power supply voltage is generally a bad idea, since most commercial amps do not have a wide safety margin with component ratings, and will probably be destroyed ... The bridging adapter shown in Figure 1 can make an amplifier produce almost 4 times the power for the same impedance - but beware of the pitfalls.
|
sound.westhost.com/project14.htm
|
|
Car Forums question about bridging amps Car Audio ... Automotive Forums .com Car Chat > Car Audio > question about bridging amps | question about bridging amps...
|
www.automotiveforums.com/t271121.html
|
|
Home > Message Board > Car Audio > Amplifiers > Archive through December 22, 2005 > Bridging 2 amps? ... Thread: Bridging 2 amps? ... I'm lookin at getting another 401DB. I know bridging mono block amps is possible, i just don't know how. any help? They're dual 2ohm subs, the amp is 2 ohm stable. right now i have the voice...
|
www.ecoustics.com/bbs/messages/4/184335.html
|
|
There are two basic approaches to bridging. One strategy is to set the first amplifier to provide all the voltage gain, then feed the output signal to both one side of the load and to the second amplifier. Either the signal has to be phase inverted between the amps or fed to the inverting input of the second amplifier.
|
[Archive] What is bridging an Amp? Amps [BG] ... TalkBass Forums > Bass Guitar Forums > Bass Guitar Forums > Amps [BG] > What is bridging an Amp?
|
www.talkbass.com/forum/archive/index.php/t-2359.html
|
|
RE: amp bridging; IP: Logged; Message:; I presently have a Kenwood KDC-MP922 head unit with the Music Keg hooked up to it. I also have (2) DEI 600d amps (old model) and just purchased the DEI 4500 that puts out 600 watts into 4 channels.
|
www.dodgedakotas.com/boards/aud/36.html
|
|
Bridging Lanzar Amps ... As a note, all bridgable amps have a common ground with two output output circuits and then the driver is connected between the outputs (even if it one is marked as -ve) for bridging. If the amp has a signal on both channels then it is already bridged internally.
|
www.t-linespeakers.org/oddsends/lanzar/bridge.html
www.t-linespeakers.org/oddsends/lanzar/bridge.html
|
|
