|
I can't believe no one here knows the difference between IDE and SATA. IDE is a shared channel between two devices, EIDE-ATAPI Optical drives or hard drives. For SATA, each device gets its own channel. As an example, try ripping two dvds at the same time on the IDE channel.
|
www.tomshardware.com/forum/218438-31-sata-optical-drive...
www.tomshardware.com/forum/218438-31-sata-optical-drives
|
|
|
|
Officially the name of the IDE interface is AT-Attachment (ATA). ... One noticeable difference between ATAPI and ATA is how command is written with the first DRQ in ATA whereas in ATAPI the command packet is written instead. The following is the series of events that must occur to send an ATAPI packet (see figure 3):
|
www.pjrc.com/mp3/gallery/cs580/ata_atapi.html
www.pjrc.com/mp3/gallery/cs580/ata_atapi.html
|
|
|
ATA/ATAPI is an evolution of the AT Attachment Interface, which was itself evolved in ... The term Integrated Drive Electronics (IDE) refers not just to the connector and .... [edit] Differences between connectors on 80 conductor cables ...
|
en.wikipedia.org/wiki/Parallel_ATA
|
|
After the Windows IDE/ATAPI Port driver (Atapi.sys) receives a cumulative total of six time-out or cyclical redundancy check (CRC) errors, the driver reduces the communications speed (the transfer mode) ... To find the difference between UTC and local time, use the Time Zone tab in the Date and Time tool in Control Panel.
|
support.microsoft.com/kb/817472
|
|
Note that in terms of configuration, it makes no difference which connector on the standard IDE cable is used in a standard IDE setup, because it is the jumpers that control master ... As long as one drive is jumpered as master and the other as slave, any two IDE/ATA/ATAPI devices should work together on a single channel.
|
www.pcguide.com/ref/hdd/if/ide/confJumpering-c.html
www.pcguide.com/ref/hdd/if/ide/confJumpering-c.html
|
|
I tried one in the last system I made - I wouldn’t recommend it and it’s mostly because DOS doesn’t like it. Besides, you have an IDE channel, might as well use it. Did you just say ‘DOS?’ the advantage of getting SATA: 1. thin cables = e...
http://www.vexstar.com/difference-between-sata-and-idea...
|
|
Shopping > Computers > Computer Storage > DVD Burners > IDE/ATAPI ... Please send us your feedback on our site. • Find, Compare, Read Reviews & Buy Find, Compare, Read Reviews & Buy DVD Burners - IDE/ATAPI Online @ Yahoo! Shopping • Want to see your products in Yahoo! Shopping? ... Understanding the Difference Between...
|
shopping.yahoo.com/s:DVD%20Burners:1013-Interface=IDE%2...
shopping.yahoo.com/s:DVD%20Burners:1013-Interface=IDE%2FATAPI
|
|
It recognizes the drive space: 76413 MB it says for the Unpartitioned Space. But is there a big difference between IDE and ATA drives/their ports/their formatting/etc ... ATA devices are also commonly called IDE, EIDE, Ultra-ATA, Ultra-DMA, ATAPI, PATA, etc.
|
answers.yahoo.com/question/index?qid=20070211071415AAfA...
answers.yahoo.com/question/index?qid=20070211071415AAfADOr
|
|
ATA/ATAPI-5, ... The picture on the right shows a flat ribbon IDE-66/100 cable with 80 wires. The extra 40 strands in an 80-wire cable act as insulators between the 40 signaling strands to prevent crosstalk. This type of cable usually has one blue connector, this connector connects to one of the mainboard's IDE connectors.
|
www.techexams.net/technotes/apluscore/ide.shtml
www.techexams.net/technotes/apluscore/ide.shtml
|
|
