|
Whatever you do, DON"T GO BY DUROMETER READINGS ALONE. They mean NOTHING when comparing tires from different "Families". I can give you 4 different tires that read 30 on the durometer. Only one will work on the rear...
|
www.rctech.net/forum/nitro-road/201986-confused-about-t...
www.rctech.net/forum/nitro-road/201986-confused-about-tire-durometer-readings.html
|
|
|
Take durometer reading every 20 degrees. If it's an autocross tire chart the durometer reading from 100 to 180 degrees, road race tires 140 to 220 degrees. I would expect the durometer readings of autocross tires to soften at 100-110 degrees and stay consistent to 160 to 180 degrees.
|
www.rsracing.com/tech-tire.htm
|
|
For the best results you should take your durometer readings as quickly as possible. Simply place the durometer on the tire surface with the footpad at a slight angle. Lightly roll the footpad until it is flat on the tire, take your reading and record the measurement.
|
www.cab-racing.com/extras/UsingATireDurometer.pdf
www.cab-racing.com/extras/UsingATireDurometer.pdf
|
|
|
The purpose of this study is to determine the motion characteristics of the foot and ankle with a durometer as a method of measurement. ... This study will assess and establish the motion characteristics of the foot and ankle with the use of a durometer as a measure of motion patterns.
|
clinicaltrials.gov/ct2/show/NCT00320554
|
|
|
Study Status: This study has been completed. ... Study Completion Date: September 2006 ... Estimated Primary Completion Date: No date given...
|
clinicaltrials.gov/ct2/show/results/NCT00320554
|
|
It uses a much smaller indenter and lighter springload than the standard A scale gauge, enabling the user to check materials as thin as .050", yet still obtain readings comparable to the standard A scale. The Micro-A gives readings to approximately +/- 2 points of a standard A scale durometer.
|
www.dynesonline.com/durometers.html
www.dynesonline.com/durometers.html
|
|
Note, on the table below Durometer A and ; Durometer D is the same as Shore A and Shore D. ... The hardness testing of plastics is most commonly measured by the Shore (Durometer) test or Rockwell hardness test. Both methods measure the resistance of the plastic toward indentation. Both scales provide an empirical...
|
www.machinist-materials.com/hardness.htm
|
|
A set of Durometer readings for the same samples is then observed and noted. Thereafter, only the Durometer hardness need be observed on similar material specimens to obtain a reasonable measure of the other property.
|
www.durometer.com/tech_notes.php
www.durometer.com/tech_notes.php
|
|
Free Online Library: Durometer test block kits obtain accurate readings. by "Rubber World"; Business Chemicals, plastics and rubber ... To obtain accurate readings using a durometer, one must develop the proper feel for the gauge, according to the company.
|
www.thefreelibrary.com/Durometer+test+block+kits+obtain...
www.thefreelibrary.com/Durometer+test+block+kits+obtain+accurate+readings.-a0143873519
|
|
