･ 1 Fill your bucket with water. The temperature should be comfortable to your hand, since you'll be submersing... ･ 2 Identify the coarse side of your drywall sponge. Just like on a dish-scrubbing sponge (which a drywall... ･ 3 Wet your sp...
http://www.ehow.com/how_4854065_wet-sand-drywall.html
|
|
･ 1 After the last coat of drywall mud is applied, let it dry at least 24 hours. ･ 2 Pick out your sanding sponge. Although the home center stores sell a sanding sponge, do not use it... ･ 3 Take your taping knife and scrape down any ridges...
http://www.ehow.com/how_4835656_drywall-sanding-wet-san...
|
|
|
Drywall dust is terrible. Here are suggestions for ways to reduce drywall dust: barrier, wet sanding, and drywall sanding vacuum. ... 2. Wet Sanding Drywall Joints...
|
homerenovations.about.com/od/wallsandtrim/f/drywalldust...
homerenovations.about.com/od/wallsandtrim/f/drywallduststop.htm
|
|
|
|
Drywall dust is very fine and invasive. To reduce the amount of dust in your house, consider wet-sponging instead of dry sanding. ... Wet Sponge Drywall Joint Compound Instead of Dry Sanding...
|
homerenovations.about.com/od/wallsandtrim/a/artwetspong...
homerenovations.about.com/od/wallsandtrim/a/artwetsponge.htm
|
|
|
Step 3 - Wet down the 4 inch knife. Then, hold the wet tape at the ... You shouldn't have to sand again. Do not use coarser grit paper except for problem areas like the meeting of 2 inside corners, or narrow strips where you can't properly use a knife to prepare the surface. Avoid sanding the paper surface of the drywall!
|
www.drywallinfo.com/tapingjoints.html
www.drywallinfo.com/tapingjoints.html
|
|
Wet sanding drywall is the process of using a wet down flat sponge to "smooth out" the bumps and ridges between coats. I don't like wet sanding drywall for the following reasons:
|
www.drywallinfo.com/wetsand.html
www.drywallinfo.com/wetsand.html
|
|
Page last updated:May 8, 2009 ; Page last reviewed:May 8, 2009 ; Content Source: National Institute for ... ; NIOSH Home | NIOSH Search | Site Index | Topic List | Contact Us; ... Search NIOSH | NIOSH Home | NIOSH Topics | Site Index | Databases and Information Resources | NIOSH Products | Contact Us...
|
www.cdc.gov/niosh/hc30.html
|
|
One of the simple and practical methods you can use to prevent airborne dust is to wet sand whenever possible. Drywall mud can be sanded with a wet sanding sponge and all the airborne dust is prevented.
|
www.wallcovering.org/dust.html
|
|
When you see pinholes tracked in wet mud, try eliminating them by repeating a pass, holding your blade with steady pressure to take them out. If you notice the ... Repair pinholes and scratches in taped drywall by wet-sanding. Select a fine-textured sponge, soak it in clean water and squeeze out most of the water.
|
www.rd.com/19400/article19400.html
|
|
