(Unformatted textual content of the document used by search engines). AN1301 APPLICATION NOTE STE100P - SINGLE PORT FAST ETHERNET TRANSCEIVER
|
www.st.com/stonline/products/literature/an/7353.htm
|
|
The VSC8244 is the industry's smallest, lowest power quad port Gigabit Ethernet transceiver for low-cost RGMII and RTBI switch and router applications. In 1000BASE-T mode, the VSC8244's power consumption is 30% lower than the next best competitor.
|
www.vitesse.com/products/product.php?number=VSC8244
|
|
"Our engineers have used their expertise in the design of electro-optics to build into our Gigabit Ethernet transceiver modules the same quality and...
|
www.thefreelibrary.com/Siemens+Announces+Gigabit+Ethern...
www.thefreelibrary.com/Siemens+Announces+Gigabit+Ethernet+Transceivers+for+Both+Longwave+and...-a019381536
|
|
Business Wire ; ...announced that its ICS 1890 Fast Ethernet transceiver is used in the innovative...physical layer interface for Fast Ethernet applications...
|
www.encyclopedia.com/doc/1G1-186298593.html
|
|
As used herein, the terms “802.3,” “Ethernet device,” “Ethernet bus,” “Ethernet network,” and “Ethernet transceiver” are all used to broadly cover any...
|
www.freepatentsonline.com/6813651.html
|
|
National is demonstrating its new Ethernet transceiver at the 2007 International IEEE Symposium on Precision Clock Synchronization in Vienna, The Precision PHYTER also may be used with some IEEE 1588-enabled processors to further improve clock synchronization accuracy for applications such as test and measurement."
|
www.national.com/news/item/0,1735,1292,00.html
|
|
The Ethernet network may be used to provide shared access by a group of attached nodes to the physical medium which connects the nodes. These nodes are said to form a Collision Domain. A faulty CD circuit, or misbehaving NIC or transceiver may lead to a late collision (i.e. after one slot time).
|
www.erg.abdn.ac.uk/users/gorry/course/lan-pages/csma-cd...
www.erg.abdn.ac.uk/users/gorry/course/lan-pages/csma-cd.html
|
|
A sub-component of one of the Ethernet transceiver modules for the ESR-PRE2 may fail prematurely under normal field use. The transceiver module was first used in November of 2005 and was phased out after March 2006 as part of an unrelated Reduction of Hazardous Substances project.
|
www.cisco.com/en/US/ts/fn/620/fn62977.html
|
|
NetPHY™-1LP Low Power 10/100-TX/FX Ethernet Transceiver; DISTINCTIVE CHARACTERISTICS; ■ 10/100BASE-TX Ethernet PHY device with; 100BASE-FX fiber optic support; ■ Typical power consumption of 0.3 W; ■ Sends/receives data reliably over cable The following table describes terms used in the pin de-scriptions.
|
www.amd.com/files/connectivitysolutions/networking/am79...
www.amd.com/files/connectivitysolutions/networking/am79c874/22235_am79c874_revK.pdf
|
|
