|
www.wswells.com/crossfeed_screw/cross_feed_screw_repair...
www.wswells.com/crossfeed_screw/cross_feed_screw_repair_instructions.html
|
Cut off the old acme cross feed screw just in front of the power feed drive gear. ... Using internal expanding arbors, hold the dial collar or bushing by the 3/8 bore, ...
|
|
www.armurerieduroi.com/pages/lathe/lathe_cross_feed.htm...
www.armurerieduroi.com/pages/lathe/lathe_cross_feed.html
|
Next Project Cross Feed Screw (Fri Sep 21, 2001), Cross feed - compound rest slop (Jul 7, 2003). New crossfeed dial (Oct 1, 2001), Crossfeed slop (Jul 24, 2003 ) ...
|
|
www.micro-machine-shop.com/cross_slide_compound_carriag...
www.micro-machine-shop.com/cross_slide_compound_carriage_gears.htm
|
Oct 20, 2011 ... Bottom of the cross slide with the bronze lead-screw nut mounted. ... The back of the Taig dial has holes for a pin-spanner wrench that I made.
|
|
www.practicalmachinist.com/vb/monarch-lathes/adjusting-...
www.practicalmachinist.com/vb/monarch-lathes/adjusting-10ee-crossfeed-screw-backlash-172175/
|
Here's a photo of the crossfeed ACME nut from my '43 round-dial: ... a radius machined in the bottom where it sits astride the crossfeed screw.
|
|
bbs.homeshopmachinist.net/showthread.php?t=7806
|
I would like to replace my crossfeed screw (7/16-10, LH) and nut (iron) ... I'd measure at about a dial reading 0.550" and see whare I was, then ...
|
|
|
|
www.home-machine-shop.com/Smithy-Support-Files/general/...
www.home-machine-shop.com/Smithy-Support-Files/general/crossfeed_backlash.pdf
|
CROSSFEED SCREW TO FRONT MOUNT. Slowly turn the crossfeed handle clockwise and watch the gap between the dial and the front screw support mount.
|
|
shdesigns.org/Craftsman-12x36/crossmod.shtml
|
Remove the cross feed screw and hub (large nut where feed screw enters cross slide. Mount the hub in a ... See later steps for a way to modify the dial instead.
|
|
www.lathe.com/6500_carriage.htm
|
The position of the cross-slide is adjusted by means of an Acme thread screw and dial. A micrometer collar on the dial is graduated in thousandths of an inch ...
|
|
www.theageofindustry.com/buying-parts-south-bend-lathe
|
To my delight the cross feed screw had the large direct reading dial instead of the small dials that came on my machine. Unfortunately the bushing that the cross ...
|
